2022思科认证模拟考试系统299

1. [单选题]标准访问控制列表应被放置的最佳位置是在（）。

A. 越靠近数据包的源越好
B. 越靠近数据包的目的地越好
C. 无论放在什么位置都行
D. 入接口方向的任何位置

2. [单选题]路由器下，由一般用户模式进入特权用户模式的命令是：（）

A. enable
B. config
C. interface
D. router

3. [单选题]OSI七层模型中，“包”是哪一层数据封装的名称（）

A. 物理层
B. 数据链路层^{(data link layer)}
C. 网络层
D. 传输层

4. [单选题]关于PPP和HDLC的说法中，错误的是（）

A. PPP是通用协议，HDLC是CISCO私有协议
B. PPP有验证功能，HDLC无验证功能
C. PPP效率低，HDLC效率高
D. 在配置ISDN时，广域网协议不能封装成PPP，但可以封装成HDLC

5. [单选题]IP地址为：192.168.50.70，掩码为：255.255.255.248，则该IP和掩码结合，共划分了多少个子网（不包括全0子网和全1子网）（）

A. 8
B. 30
C. 6
D. 14

6. [多选题]在配置帧中继子接口时，在物理接口上应该配置的内容是：()

A. 配置IP地址
B. 封装帧中继协议^{(fr protocol)}
C. 指定子接口类型
D. 设定子接口
E. 配置密码

7. [单选题]You are a senior network administrator at Ezonexam, and while performing the password recovery procedure on your 2500 series Cisco router, you type in the following command:o/r 0x2142

A. What is the purpose of this command?
B. It is used to restart the router.
C. It is used to bypass the configuration in NVRAM.
D. It is used to enter ROM Monitor mode.
E. It is used to view the lost password.
F. It is used to save the changes to the configuration.

8. [单选题]You have just purchased a brand new router and wish to have the router prompt you through the initial configuration commands. Which router mode does this describe?

A. ROM Monitor mode
B. SETUP mode
C. Autoflash mode
D. RXBOOT mode
E. None of the above

9. [单选题]The Ezonexam LAN is upgrading all devices to operate in full duplex. Which statement is true about full-duplex Ethernet in comparison to half-duplex Ethernet?

A. Full-duplex Ethernet uses two wires to send and receive. Half-duplex Ethernet uses one wire to send and receive
B. Full-duplex Ethernet consists of a shared cable segment. Half-duplex Ethernet provides a point-to-point link
C. Full-duplex Ethernet can provide higher throughout than can half-duplex Ethernet of the same bandwidth
D. Full-duplex Ethernet uses a loopback circuit to detect collisions. Half-duplex ethernet uses a jam signal
E. None of the above

10. [多选题]Which of the following are types of flow control? (Choose three)

A. Buffering
B. Cut-through
C. Windowing
D. Congestion avoidance
E. Load balancing

查看答案&解析查看所有试题

本文链接：https://www.51ksbd.net/show/69j0j3.html