2022思科认证模拟考试题免费下载249

1. [单选题]对于路由表，下列说法中正确的是：（）

A. 在缺省的情况下，如果一台路由器同时运行了RIP和OSPF两种动态路由协议，则在路由表中只会显示RIP发现的路由，因为RIP协议的优先级更高
B. 在缺省的情况下，如果一台路由器同时运行了RIP和OSPF两种动态路由协议，则在路由表中只会显示OSPF发现的路由，因为OSPF协议的优先级更高
C. 在缺省的情况下，如果一台路由器同时运行了RIP和OSPF两种动态路由协议，则在路由表中只会显示RIP发现的路由，因为RIP协议的花费值（metric）更小
D. 在缺省的情况下，如果一台路由器同时运行了RIP和OSPF两种动态路由协议，则在路由表中只会显示OSPF发现的路由，因为OSPF协议的花费值（metric）更小

2. [单选题]查看路由表的命令是：()

A. show interface
B. show run
C. show ip route
D. show table

3. [单选题]OSI七层模型中，“包”是哪一层数据封装的名称（）

A. 物理层
B. 数据链路层^{(data link layer)}
C. 网络层
D. 传输层

4. [单选题]如果网络中的路由器都是cisco路由器，则优先选择哪一个路由协议（）

A. RIP
B. EIGRP
C. IGRP
D. OSPF

5. [单选题]IP地址为：192.168.50.70，掩码为：255.255.255.248，则该IP和掩码结合，共划分了多少个子网（不包括全0子网和全1子网）（）

A. 8
B. 30
C. 6
D. 14

6. [单选题]路由器“路由模式”的提示符号是（）

B. (config)
C. (config-if)
D. (config-router)

7. [单选题]路由器当前的模式为“端口模式”，要退回到“特权模式”，应该使用的快捷键^{(shortcut key)}为（）

A. ctrl+b
B. ctrl+z
C. ctrl+c
D. ctrl+p

8. [多选题]How could the Ezonexam corporation benefit from using VLANs on their network?(Select three answer choices.)

A. VLANs allow access to network services based on department, not physical location.
B. VLANs utilize packet filtering to enhance network security.
C. VLANs provide a low-latency, high bandwidth internetworking alternative.
D. VLANs provide a method of communication between IP addresses in large networks.
E. VLANs establish segmented broadcast domains in switched networks.
F. F. VLANs can greatly simplify adding, moving, or changing hosts on the network.

9. [单选题]While troubleshooting a connectivity problem on the network, you issue the ping command from your PC command prompt, but the output shows "request times out."At which OSI layer is this problem associated with?

A. The data link layer
B. The application layer
C. The access layer
D. The session layer
E. The network layer

10. [单选题]A new Ezonexam switch is installed into an existing LAN and a new VTP trunk is set up with an existing switch. Which VLANs will be allowed on this new trunk?

A. All defined VLANs are allowed on the trunk by default.
B. Each VLAN, or VLAN range, that is specified with the switchport mode command.
C. Each VLAN, or VLAN range, that is specified with the vtp domain command.
D. Each VLAN, or VLAN range, that is specified with the vlan database command.
E. None of the above

查看答案&解析查看所有试题

本文链接：https://www.51ksbd.net/show/7ev4nr.html