布丁学网

The Ezonexam network administrator issues the ping 192.168.2

  • 下载次数:
  • 支持语言:
  • 1966
  • 中文简体
  • 文件类型:
  • 支持平台:
  • pdf文档
  • PC/手机
  • 【名词&注释】

    帧中继(frame relay)、第二层(the second layer)

  • [多选题]The Ezonexam network administrator issues the ping 192.168.2.5 command and successfully tests connectivity to a host that has been newly connected to the network. Which protocols were used during the test? (Choose two)

  • A. ARP
    B. CDP
    C. DHCP
    D. DNS
    E. ICMP

  • 查看答案&解析查看所有试题
  • 学习资料:
  • [单选题]OSPF骨干区的区域编号为()
  • A. 0.0.0.1
    B. 255
    C. 0.0.0.0
    D. 255.255.255.255

  • [单选题]OSI第二层数据封装完成后的名称是:()
  • A. 比特
    B. 包
    C. 帧
    D. 段

  • [单选题]查看E0端口配置信息的命令是:()
  • A. show access-list
    B. show ip route
    C. show version
    D. show interfacee0

  • [单选题]下列对RIP的配置中,合法的命令是()
  • A. router rip 100 network 10.12.0.0
    B. router rip 100 network 10.0.0.0
    C. router rip network 10.12.0.0
    D. router rip 100 network 10.0.0.0

  • [单选题]帧中继环境中,CIR的含义是()
  • A. 提高线路速率
    B. 保证线路速率
    C. 降低线路速率
    D. 配置线路速率

  • [单选题]EIGRP的管理距离()
  • A. 90
    B. 100
    C. 110
    D. 120

  • [单选题]An administrator issues the show ip interface s0/0 command and the output displays that interface Serial0/0 is up, line protocol is up.What does "line protocol is up" specifically indicate about the interface?
  • A. The cable is attached properly.
    B. CDP has discovered the connected device.
    C. Keepalives are being received on the interface.
    D. A carrier detect signal has been received from the connected device.
    E. IP is correctly configured on the interface.

  • [多选题]Using a subnet mask of 255.255.255.224, which of the IP addresses below can you assign to the hosts on this subnet? (Select all that apply)
  • A. 16.23.118.63
    B. 87.45.16.159
    C. 92.11.178.93
    D. 134.178.18.56
    E. 192.168.16.87
    F. F. 217.168.166.192

  • [多选题]You are bringing up a new Ezonexam switch, and wish to connect it via a trunk to another switch from a different vendor, which uses the IEEE standard for the trunking method. When setting the encapsulation type on the trunk, what should you configure on the Cisco switch?
  • A. Switch(config) switchport trunk encapsulation isl
    B. Switch(config) switchport trunk encapsulation ietf
    C. Switch(config-if) switchport trunk encapsulation isl
    D. Switch(config-if) switchport trunk encapsulation ietf
    E. Switch(config-if) switchport trunk encapsulation dot1q

  • 本文链接:https://www.51ksbd.net/show/8j9zqw.html
  • 推荐阅读
    @2019-2025 布丁学网 www.51ksbd.net 蜀ICP备20012290号-1 川公网安备 51012202001362号