2022计算机类考试思科认证模拟考试练习题314

1. [单选题]On a half-duplex Ethernet LAN, two hosts attempt to send data simultaneously, resulting in a collision. Following this collision, what will the hosts do? (Select all valid answers)

A. The destination host sends a request to the source for retransmission.
B. The jam signal indicates that the collision has been cleared.
C. The hosts will attempt to resume transmission after a time delay has expired.
D. An electrical pulse indicates that the collision has cleared.
E. The router on the segment will signal that the collision has cleared.
F. F. The hosts will do nothing, as the higher layers are responsible for data error correction and re-transmission.

2. [单选题]把访问权限表应用到路由器端口的命令是：()

A. permit access-list 101 out
B. ip access-group 101 out
C. apply access-list 101 out
D. access-class 101 out

3. [单选题]路由器上，清空路由表的命令是（）

A. clear ip
B. delete ip route
C. delete route
D. clearip route*

4. [单选题]While troubleshooting a connectivity problem on the network, you issue the ping command from your PC command prompt, but the output shows "request times out."At which OSI layer is this problem associated with?

A. The data link layer
B. The application layer
C. The access layer
D. The session layer
E. The network layer

5. [多选题]As a Ezonexam trainee you are required to set the default gateway on a Cisco switch to the IP address of 192.168.1.115. Which IOS command should you use?

A. TestKSwitch(config) ip route-default 192.168.1.115
B. TestKSwitch(config) ip default-gateway 192.168.1.115
C. TestKSwitch(config) ip route 192.168.1.115 0.0.0.0
D. TestKSwitch(config) ip default-network 192.168.1.115
E. None of the above

6. [多选题]In which Spanning-Tree states does a switch port learn MAC addresses? (Select two)

A. Blocking
B. Listening
C. Forwarding
D. Learning
E. Relaying

7. [单选题]A receiving host has failed to receive all of the segments that it should acknowledge.What can the host do to improve the reliability of this communication session?

A. Start a new session using UDP
B. Obtain a new IP address from the DHCP server
C. Use a different source port for the session
D. Decrease the sequence number
E. Decrease the window size

8. [多选题]Which three statements are true about the operation of a full-duplex Ethernet network, which is being used in the Ezonexam LAN? (Choose three)

A. Ethernet hub ports are preconfigured for full-duplex mode.
B. The host network card and the switch port must be capable of operating in full-duplex mode.
C. There are no collisions in full-duplex mode.
D. In a full-duplex environment, the host network card must check for the availability of the network media before transmitting.
E. A dedicated switch port is required for each full-duplex node.

9. [单选题]You need to perform. some initial configuration tasks on a new Ezonexam switch. What is the purpose of assigning an IP address to a switch?

A. To provide local hosts with a default gateway address
B. To allow remote management of the switch.
C. To allow the switch to respond to ARP requests between two hosts
D. To ensure that hosts on the same LAN can communicate with each other.
E. None of the above

查看答案&解析查看所有试题

本文链接：https://www.51ksbd.net/show/j6y4yv.html