NAT可以被用于完成多种功能，以下不属于其功能的是：（）

【名词&注释】

路由表(routing table)、路由器(router)、交换机(switch)、目的地(destination)、帧中继(frame relay)、优先选择(priority selection)、网络流量控制(network traffic control)

[单选题]NAT可以被用于完成多种功能，以下不属于其功能的是：（）

A. 转换内部局部地址
B. 内部全局地址复用
C. TCP负载均衡
D. 内部网络流量控制^{(network traffic control)}

查看答案&解析查看所有试题

学习资料：

[单选题]On a half-duplex Ethernet LAN, two hosts attempt to send data simultaneously, resulting in a collision. Following this collision, what will the hosts do? (Select all valid answers)

A. The destination host sends a request to the source for retransmission.
B. The jam signal indicates that the collision has been cleared.
C. The hosts will attempt to resume transmission after a time delay has expired.
D. An electrical pulse indicates that the collision has cleared.
E. The router on the segment will signal that the collision has cleared.
F. F. The hosts will do nothing, as the higher layers are responsible for data error correction and re-transmission.

[单选题]交换机转发数据到目的地依靠()

A. 路由表
B. MAC地址表
C. 访问权限表
D. 静态列表

[单选题]在启用IGRP协议时，所需要的参数是：()

A. 网络掩码
B. 子网号
C. 自治系统号
D. 跳数

[单选题]介质100BaseT的最大传输距离是：()

A. 10m
B. 100m
C. 1000m
D. 500m

[单选题]如果网络中的路由器都是cisco路由器，则优先选择^{(priority selection)}哪一个路由协议（）

A. RIP
B. EIGRP
C. IGRP
D. OSPF

[单选题]帧中继环境中，在物理端口上，建立子接口的命令是（）

A. create
B. interface
C. encapsulation
D. ip address

[单选题]From where does a small network typically get its IP network addresses or IP block?

A. From the Internet Domain Name Registry (IDNR)
B. From the Internet Assigned Numbers Authority (IANA．
C. From the Internet Service Provider (ISP)
D. From the Internet Architecture Board (IAB．
E. None of the above

[单选题]Study the Exhibit below carefully:London#show vtp

A. VTP Version: 2
B. Configuration Revision: 0
C. Maximum VLANs supported locally: 64
D. Number of existing VLANs: 5
E. VTP Operating Mode: Client
F. VTP Domain Name: London
G. VTP Pruning Mode: Disabled
H. VTP V2 Mode: Disabled
I. VTP Traps Generation: Disabled
J. Based on the information given above, what is the VTP function of this particular switch?
K. Learn and save VTP configuration in the running configuration.
L. Create and change VLANs.
M. Forwards information about VTP configuration.
N. VTP is disabled on this device.
O. VTP is not saved to NVRAM.

本文链接：https://www.51ksbd.net/show/r4dwj7.html