2022思科认证考前点睛模拟考试294

1. [单选题]当拓扑信息完成交换，相邻路由器具有相同的LSDB时，下列哪项OSPF邻居状态是希望得到的()

A. 2-WAY
B. FULL
C. Exchange
D. Loading

2. [单选题]SMTP工作在OSI哪一层（）

A. 会话层^{(session layer)}
B. 表示层
C. 传输层
D. 应用层

3. [单选题]下列路由协议中，属于链路状态路由协议的是（）

A. RIP
B. EIGRP
C. IGRP
D. OSPF

4. [单选题]路由器上，清空路由表的命令是（）

A. clear ip
B. delete ip route
C. delete route
D. clearip route*

5. [多选题]You need to configure an 802.1Q link on a Ezonexam switch. Which commands, when used together, would do this? (Select two answer choices)

A. Switch(vlan) mode trunk
B. Switch(config) switchport access mode trunk
C. Switch(config-if) switchport mode trunk
D. Switch(config-if) switchport trunk encapsulation dot1q
E. Switch(config) switchport access mode 1
F. F. Switch(vlan) trunk encapsulation dot1q

6. [多选题]交换机的三大功能为（）

A. 地址学习
B. 转发过滤
C. 消除回路
D. 发送数据包^(packet)

7. [多选题]There are 2 switches in the Ezonexam LAN, with no routers. Ports 1, 2 & 3 are assigned to VLAN 1 in switch 1 and 2 and ports 4, 5 & 6 are assigned to VLAN 2 in both switches. These two switches are connected together via a trunked link. Which of the conditions below would verify trunk and VLAN operation? (Select all valid answers)

A. Host 1 on VLAN 1 can ping Host 2 on VLAN 1
B. Host 1 on VLAN 1 can ping Host 4 on VLAN 2
C. Host 1 on VLAN 1 can not ping Host 2 on VLAN 1
D. Host 4 on VLAN 2 can not ping Host 1 on VLAN 1
E. Host 4 on VLAN 2 can ping Host 2 on VLAN 2

8. [单选题]The Ezonexam LAN is upgrading all devices to operate in full duplex. Which statement is true about full-duplex Ethernet in comparison to half-duplex Ethernet?

A. Full-duplex Ethernet uses two wires to send and receive. Half-duplex Ethernet uses one wire to send and receive
B. Full-duplex Ethernet consists of a shared cable segment. Half-duplex Ethernet provides a point-to-point link
C. Full-duplex Ethernet can provide higher throughout than can half-duplex Ethernet of the same bandwidth
D. Full-duplex Ethernet uses a loopback circuit to detect collisions. Half-duplex ethernet uses a jam signal
E. None of the above

9. [单选题]A new Ezonexam switch is installed into an existing LAN and a new VTP trunk is set up with an existing switch. Which VLANs will be allowed on this new trunk?

A. All defined VLANs are allowed on the trunk by default.
B. Each VLAN, or VLAN range, that is specified with the switchport mode command.
C. Each VLAN, or VLAN range, that is specified with the vtp domain command.
D. Each VLAN, or VLAN range, that is specified with the vlan database command.
E. None of the above

查看答案&解析查看所有试题

本文链接：https://www.51ksbd.net/show/xxy85l.html