正确答案: AE

ARP ICMP

题目：The Ezonexam network administrator issues the ping 192.168.2.5 command and successfully tests connectivity to a host that has been newly connected to the network. Which protocols were used during the test? (Choose two)

解析：解析：Explanation:ARPfindsthehardwareaddressofahostfromaknownIPaddress.Here'showitworks:whenIPhasadatagramtosend,itmustinform.aNetworkAccessprotocol,suchasEthernetorTokenRing,ofthedestination'shardwareaddressonthelocalnetwork.(Ithasalreadybeeninformedbyupper-layerprotocolsofthedestination'sIPaddress.)IfIPdoesn'tfindthedestinationhost'shardwareaddressintheARPcache,itusesARPtofindthisinformation.ICMPworksattheNetworklayerandisusedbyIPformanydifferentservices.ICMPisamanagementprotocolandmessagingserviceproviderforIP.ItsmessagesarecarriedasIPdatagrams.RFC1256isanannextoICMP,whichaffordshosts'extendedcapabilityindiscoveringroutestogateways.Periodically,routeradvertisementsareannouncedoverthenetwork,reportingIPaddressesfortherouter'snetworkinterfaces.Hostslistenforthesenetworkinfomercialstoacquirerouteinformation.Aroutersolicitationisarequestforimmediateadvertisementsandmaybesentbyahostwhenitstartsup.

查看原题查看所有试题

学习资料的答案和解析：

[单选题]OSPF骨干区的区域编号为（）

0.0.0.0

[单选题]OSI第二层数据封装完成后的名称是：()

帧

[单选题]查看E0端口配置信息的命令是：()

show interfacee0

[单选题]下列对RIP的配置中，合法的命令是（）

router rip network 10.12.0.0

[单选题]帧中继环境中，CIR的含义是（）

保证线路速率

[单选题]EIGRP的管理距离（）

110

[单选题]An administrator issues the show ip interface s0/0 command and the output displays that interface Serial0/0 is up, line protocol is up.What does "line protocol is up" specifically indicate about the interface?

Keepalives are being received on the interface.

解析：解析：Explanation:

[多选题]Using a subnet mask of 255.255.255.224, which of the IP addresses below can you assign to the hosts on this subnet? (Select all that apply)

92.11.178.93

134.178.18.56

192.168.16.87

解析：C,D,E 解析：Explanation:

[多选题]You are bringing up a new Ezonexam switch, and wish to connect it via a trunk to another switch from a different vendor, which uses the IEEE standard for the trunking method. When setting the encapsulation type on the trunk, what should you configure on the Cisco switch?

Switch(config) switchport trunk encapsulation isl

Switch(config) switchport trunk encapsulation ietf

Switch(config-if) switchport trunk encapsulation isl

Switch(config-if) switchport trunk encapsulation ietf

Switch(config-if) switchport trunk encapsulation dot1q

解析：解析：Explanation: