• [单选题]On a half-duplex Ethernet LAN, two hosts attempt to send data simultaneously, resulting in a collision. Following this collision, what will the hosts do? (Select all valid answers)
  • 正确答案 :C
  • The hosts will attempt to resume transmission after a time delay has expired.

  • 解析:C 解析:Explanation:

  • [单选题]把访问权限表应用到路由器端口的命令是:()
  • 正确答案 :B
  • ip access-group 101 out


  • [单选题]路由器上,清空路由表的命令是()
  • 正确答案 :D
  • clearip route*


  • [单选题]While troubleshooting a connectivity problem on the network, you issue the ping command from your PC command prompt, but the output shows "request times out."At which OSI layer is this problem associated with?
  • 正确答案 :E
  • The network layer

  • 解析:解析:Explanation:

  • [多选题]As a Ezonexam trainee you are required to set the default gateway on a Cisco switch to the IP address of 192.168.1.115. Which IOS command should you use?
  • 正确答案 :ABCD
  • TestKSwitch(config) ip route-default 192.168.1.115

    TestKSwitch(config) ip default-gateway 192.168.1.115

    TestKSwitch(config) ip route 192.168.1.115 0.0.0.0

    TestKSwitch(config) ip default-network 192.168.1.115

  • 解析:解析:Explanation:

  • [多选题]In which Spanning-Tree states does a switch port learn MAC addresses? (Select two)
  • 正确答案 :CD
  • Forwarding

    Learning

  • 解析:解析:Explanation:

  • [单选题]A receiving host has failed to receive all of the segments that it should acknowledge.What can the host do to improve the reliability of this communication session?
  • 正确答案 :E
  • Decrease the window size

  • 解析:解析:Explanation:

  • [多选题]Which three statements are true about the operation of a full-duplex Ethernet network, which is being used in the Ezonexam LAN? (Choose three)
  • 正确答案 :BCE
  • The host network card and the switch port must be capable of operating in full-duplex mode.

    There are no collisions in full-duplex mode.

    A dedicated switch port is required for each full-duplex node.

  • 解析:解析:Explanation:

  • [单选题]You need to perform. some initial configuration tasks on a new Ezonexam switch. What is the purpose of assigning an IP address to a switch?
  • 正确答案 :B
  • To allow remote management of the switch.

  • 解析:解析:Explanation:Switchisalayer2deviceanddoesn'tusenetworklayerforpacketforwarding.TheIPaddressmaybeusedonlyforadministrativepurposessuchasTelnetaccessorfornetworkmanagementpurposes.

  • 查看原题 查看所有试题

    推荐科目: 计算机三级 微软认证 思科认证 JAVA认证 计算机一级 软考初级 职称计算机 计算机操作员初级 计算机操作员高级 LTE认证
    @2019-2025 布丁学网 www.51ksbd.net 蜀ICP备20012290号-1 川公网安备 51012202001362号